Vinyl Guard Covering
50 mm thick Vinyl Guard covering (shrink-wrap) smoothly conforms to tightly fit the contours of straight and tapered metal rollers, protecting wood, glass and delicate finishes. Sold in 5ft lengths, please contact us for a quotation
Abrasion resistant, shrink-to-fit vinyl tubing
- Protects and cushions wood, fragile glass and delicate finishes and surfaces against scratches and damage from bare metal
- Significantly reduces noise
- Standard sizes available for all popular roller diameters
- Custom diameter sizes and colours available
- USFDA (21CFR) Food-Grade vinyl available
Cost-effective protection for your equipment
- Long-lasting – 85 durometer hardness
- Custom engineered vinyl resists chemicals, oils, grease, acids, chlorinated cleansers, moisture, corrosion
- Non-marking material will not stain, rust, crack or peel
- Reduces ‘wear and tear’ on metal rollers
- Easy to clean
How to Cover Straight and Tapered Conveyor Rollers with VinylGuard
To Start
- Cut a length of VinylGuard® 2″ longer than the conveyor roller to allow for longitudinal shrinkage
- Slide the VinylGuard® over the roller, overlapping each end 1″
For Straight Conveyor Rollers
- For small quantities use a high temperature heat gun with a high velocity air blower
- To quickly shrink larger quantities use a convection oven or a conveyor oven
For Tapered Conveyor Rollers
Using a Heat Gun
- Hold the hear gun at a 45° angle, 3″ to 4″ away from material to prevent burning
- CAUTION – Do not apply excessive hear directly to the crease
- Slowly begin shrinking at one end and rotate the roller while rapidly moving the heat gun back and forth to avoid burning the vinyl. Apply sufficient heat to remove any winkles
- Allow the conveyor roller to fully cool
- Trim the excess vinyl with a sharp blade or utility knife and apply a little heat to remove any wrinkles
Using a Convection Oven
- In a 300°F convection oven, place the conveyor rollers in a jig or holding fixture to allow the hot air to circulate
- The rollers should remain in the oven for approximately 4 minutes
- Remove the rollers from the oven and allow them to fully cool
- Trim the excess vinyl with a sharp blade or utility knife
Using a Conveyor Oven
- In a 300°F (149°C) conveyor oven, place the rollers on the conveyor
- Adjust the conveyor speed to allow the rollers to remain in the oven for approximately 4 minutes
- Remove the rollers from the oven and allow them to fully cool
- Trim the excess vinyl with a sharp blade or utility knife
After shrinking and fully cooling, VinylGuard will not slip or loosen on the conveyor rollers